Step-by-step instructions to gluing inner corners
When finishing, the most important problem can be uneven walls and the resulting folds on the wallpaper. It’s also vital to take into consideration that as soon as the walls are crooked, the joints of wallpaper canvases could invisibly.
After gluing gidpola.ru the last one in the front of the interior corner of the cloth should measure the remaining space. It is measured from the edge of the glued cloth to the adjacent wall, and the resulting figure is added 10-15 millimeters. If the walls are extremely curved, then the additional figure could be .
Cut a strip equal to the resultant figure, taking into consideration the allowance. The surfaces have been treated with adhesive. Based on the type of coating it might be precisely the wall or surfaces.
The strip has been glued individually using the cut side into the wallsocket. The background should go on the opposite plane.
In case the glued background is wrinkled, you need to make a few smaller cuts perpendicular to the folds.
Level or incline on the adjoining wall is a perpendicular line. The distance from the corner is equal to the width of the last cut strip, never including additions.
The surfaces are smeared with adhesive, and the coat is glued into the wall with the flat side towards the line. The cut side goes on the adjoining wall.
How to glue the outer corner (outer corner)?
Protruding corner should be glued by analogy with an interior, however there are little gaps, which also have to be taken into account when working.
Measured the space remaining out of the glued background into the adjoining wall. Add 20-25 millimeters to the obtained figure.
A segment is cut off, considering the added 20-25 millimeters.
Prior to gluing, the surfaces have been treated with glue.
The even edge has to be glued to the wallpaper already fixed onto the wall, the own cut side”extends” into the adjacent plane. If needed, small cuts are created in the area of visiting the other wallpaper, smoothed and pressed into the wall.
Draw a vertical strip onto the adjacent wall in a distance of only glued cut strip plus 6-10 millimeters.
After applying the glue, the strip is put on the wall with its flat side to the marked line, going over the edge of the glued strip.
The joints have been smeared with glue and ironed using a rollercoaster. Following that, the upper layer is trimmed across the ruler and the 2 layers are combined together.